Recently Updated Pages

Test the PH of the water Locate the PH test strips, in the computer cubby hole at the CNC Plas...

Accepted: 4.01.2024 These rules and policies are subject to change. Changes will become effectiv...

Overview At Protohaven we aim to provide a safe and collaborative environment for all members to...

TODO: We should set up a task to check the thermostats History at: https://app.asana.com/1/11996...

Where to obtain materials, consumables, and tooling. The Tormach document library C...

Dice: Dice.step  

The drive belt is a 4mm polyurethane cut at 60". The ends are joined by heating with a heat knife...

Definition Personal Identifiable Information (PII) is defined as: Any representation of infor...

Manual Metal Lathe The lathe is used to make parts with radial symmetry and can be used to make ...

60 degree engraving bits are a great place to start.  These are the ones used in the class: Amaz...

*Recharge Desiccant Pack* 1. Remove the white rectangular plastic desiccant pack from the "free ...

Introduction Notes Safety Hot parts, Compressed air hazard, pinch points (electric assisted ...

*Compare Online and Physical Tool States*1. Open https://api.protohaven.org/techs 2. Make a note ...

A temperature probe on the heat shield under the heater when it's pushed back would help a lot wi...

Formech_686_mHUB_User_Guide_.pdf Formech_686_owners_service_and_opertation.pdf Vacuum-Forming...

*Materials*For a disinfectant, you can use sanitizing spray (kept under the kitchen sink, with re...

Vectric VCarve Pro Makerspace edition VCarve Makerspace Edition is a special version of VCarve t...

CNC Wood Router (Avid Pro 60x120) The Avid CNC router is used to run cutting and milling operati...

Service manual: PENDING*Inspect the Blade*Inspect the saw blade for wear and damage.1. If any tee...

Introduction The Rockwell hardness tester is primarily for testing the hardness of steels. The ...