Search Results

Overview Clean out any debris from the filter box underneath the machine Put in a tool report + Asana task to change the filter if it looks dirty. Procedure Setup Wear a dust mask Locate the jewelry area shop vac and bring it to the polishing...

Definition Personal Identifiable Information (PII) is defined as: Any representation of information that permits the identity of an individual to whom the information applies to be reasonably inferred by either direct or indirect means. Further, PII is def...

Install Docker We rely heavily on using docker containers to run the various services in a dev environment - make sure Docker is installed first before continuing. Clone the repository & set up pre-commit Next, let's grab the code and set up pre-commit, whi...

Manuals and other reference materials from the manufacturer or other sources. IronWorker- IW5502_Ironworker 55T_COMBINED.pdf

Where to obtain materials, consumables, and tooling.

Edwards 55 Ton Ironworker The ironworker’s main strength is its versatility. It can shear, punch, and notch a variety ofdifferent materials. The ironworker consists of three primary sections: The shear,the notcher and the punch. Shear This section of the ...

Cold Saw The cold saw makes accurate, square and angled cuts in steel and aluminum. The saw is heavy and stable and the dual vise clamping system makes for more accurate cuts than an abrasive chop saw with minimal burring, almost like a machined edge. It uses...

Manuals and other reference materials from the manufacturer or other sources. Jet Manual Ferrous Cold Saw- 414214_man_EN.pdf

Where to obtain materials, consumables, and tooling.

Approved and prohibited materials for the laser cutters. Approved Materials for Rabbit Laser Cutters Scroll up and down to see the list; scroll right for additional information. Approved Materials for Trotec Laser Cutter Scroll up and down to see the lis...

Check for Storage Violations Open any lockers without storage tags and look for any materials stored there. Examine all board/bar and sheet storage for items stored without storage tags. Check for any cages with stored items that are also missing a storag...

Clean the Interior Open the side panel. Dredge out any buildup of chips, gunk, and other debris. Ensure the cutting fluid can make its way to the sight glass on the bottom right of the machine. If it's not visible, submit a maintenance request so a traine...

Wiki page: https://protohaven.org/wiki/tools/air_compressor#maintenance_schedule Service manual: https://drive.google.com/file/d/1XzDx7dxhe-dacSaEM6lDuwz62_uSK6YC/view Task List Wear safety glasses and hearing protection Check for proper oil level (withi...

Service manual: https://drive.google.com/file/d/17N-GZd98lkBZe_qzui03i1omQ-WQyV2a/view Clean and Lubricate Wipe off or vacuum the accumulated debris and dust. Lubricate the arbor press ram with a light machine oil. Check and Service Ram Check the ram ...

Fire extinguishers are located in the following areas: Kitchen Wood Shop Maintenance Room Blacksmithing  Front Entrance For each fire extinguisher: Verify that all fire extinguishers are pressurized (indicator is in the green range).  Verify that...

Check the inventory for the first aid kits. Restock any low supplies; backstock is stored in Custodial. Submit purchase requests if anything is needed - especially bandages as they disappear quickly. There are three first aid kits - one each in the Kitchen, W...

Check all electrical outlets on ceiling drops and floor runs for loose outlets and/or cable clamps, improper use of "punch-out" junction boxes, or improper use of "power strips" not installed and used in accordance with instructions included in the listing, la...

Flush the Eyewash Station Run the eyewash station for  1-3 minutes. (This flushes any stagnant water from the line.)