Advanced Search
Search Results
5 total results found
Check workshop outlets
Check all electrical outlets on ceiling drops and floor runs for loose outlets and/or cable clamps, improper use of "punch-out" junction boxes, or improper use of "power strips" not installed and used in accordance with instructions included in the listing, la...
Check First Aid Kits for low levels of supply
Check the inventory for the first aid kits. Restock any low supplies; backstock is stored in Custodial. Submit purchase requests if anything is needed - especially bandages as they disappear quickly. There are three first aid kits - one each in the Kitchen, W...
Powder Coating Ovens (both large and small) - Clean and inspect
*Safety*- Wear a dust mask.- Wear safety glasses.*Task List*To wipe down oven surfaces, use a clean shop rag and a mixture of water with a little soap. Just lightly damp, not dripping wet. (Do not use solvent-based cleaners, as they can affect the powder cure....
Clean/Lubricate the X/Y/Z Axis of the 3d printers
Clean/Lubricate the X/Y/Z Axis of the 3d printers Grab the cleaning kit. Located on the shelf in the 3d printer cabinet. Use the Z Axis cleaning device in the kit. If a replacement is needed: https://www.printables.com/model/229145-z-axis-screw-cleaning-...
Injection molder - lubricate clamp system
Ensure there are no obstructions inside the chamber - should just be a couple aluminum blocks. Identify the "PUSH TO CLAMP" knob on the bottom left of the machine, and the locking lever underneath it Slide the lock lever to the right, then push the knob in...