Skip to main content

Tool Tutorial

Drum Sander

(LinkThe Grizzly G1066Z Drum Sander uses two rotating drums covered with sandpaper to PDFremove a small amount of material from wood workpieces. The two drums use coarse, then fine sandpaper to achieve a fine finish in one pass.

Notes

  • Maximum depth of cut: 1/4 turn = 1/64" = 0.4mm
  • The Drum Sander and Planer cannot be operated at the same time

Safety

  • Do not edge sand workpieces.
  • Do not stand directly in front of the sander's infeed area.
  • Do not sand boards under 9" x 2" x 1/8".
  • Do not sand more than one board at a time.
  • Use a dust mask, hearing protection, and safety glasses.

Common Hazards

  • "Kickback" is when a workpiece is propelled out of the machine by a spinning drum. It can be caused by:
    • Sanding more than one board at a time
    • Taking too deep a cut
    • Sanding a workpiece less than 9" x 2" x 1/8"
    • Sanding a
  • Fine dust left on the floor is a slip hazard.
  • Excessively cupped, bowed, or twisted workpieces are unstable and unpredictable, and may be propelled from the machine.

Care 

  • Do not cut wet wood (over 20% moisture)
  • Do not cut boards with finish or excessive glue applied
  • Run workpieces through at different positions left-to-right for even wear on the sandpaper.
  • Do not sand boards with finish or uncured glue applied. Use a sacrificial piece of sandpaper or first remove finish layers with the resaw bandsaw. Sanding boards with high resin content or applied finishes will quickly contaminate and clog sandpaper.

Use

Materials

  • Only wood should be used.
  • Nails, screws, staples, etc embedded in the wood can damage the machine.

Consumables

Parts of the Tool

Tutorial)

  • Manual contains annotated images

Basic Operation

Setting Up

  1. Open the top cover and inspect the drums for wear on the sandpaper.
  2. Make sure the wall-mounted power switch is set to "Drum Sander" if no one is already using the planer.
  3. Make sure the shop dust collection is turned on.

Using the Tool

  1. Lower the conveyor so your workpiece can fit comfortably, to avoid taking a cut more than 1/64"
  2. Turn on the Sanding Drum Motor first, to ensure work is loaded only while the drum is spinning.
  3. Turn on the Conveyor Motor, starting with a slow speed.
  4. Make light test passes to find an appropriate conveyor speed.
    • If the Sanding Load meter gets too high, lower the speed or cut depth.
    • If the wood is burning, increase the speed or decrease the cut depth.

Cleaning Up

  1. Sweep or vacuum dust left on the floor around the machine
  2. If the 
Back to top