CNC Plasma 14 Day Maintenance

Test the PH of the water

1. Locate the PH test strips, in the computer cubby hole at the CNC Plasma Computer station.  
2. Use a stick or other object to lightly stir the water in the table. Just lightly move the water in between the slats, careful not to splash out. Stir at least half the table. 
3. Remove one PH test strip from the bottle, seal the bottle back up quickly and make sure the lid is snug, the strips will go bad when exposed to air. 
4. Dip the colored end of the strip into the water for about 1 second. Remove and shake excess fluid from the strip. 
5. Compare the strip to the color chart on the bottle. You may need to spin the strip 180º to get the colors to line up. 
6. Take note of the PH reading. 
7. Make an Air Table (Not ASANA) tool report,report, noting the PH reading. If the PH reading is NOT 9-10, check the box on the report to make an asana task to adjust the PH level of the table.