Clean catch boxes below lasers 1 and 2

Underneath the Rabbit lasers there's a cabinet, containing a box that collects any small pieces of material that fall through the honeycomb.

Clean the Catch Boxes

For each of the large format lasers:
 
1. Unlatch and open the bottom panel in the front of the machine.
2. Find the handled catch box towards the top of the open space.
3. Remove the catch box by pulling it forward, then down and out of the machine.
4. Dump any contained loose material into a trash can.
5. Wipe away any remaining soot and debris with damp paper towel.
6. Clean any buildup of residue on the rear vent slots with plastic bristle brush (found on top of the black cabinets)
7. Replace the catch box, 
8. Close and latch the bottom panel.